Hump magnet separators are used to remove ferrous contaminants iron nuts, bolts, wire, banding etc. from the conveyed material. With the hinged doors, cleaning the magnetic surface is quick and easy. The unit can be mounted directly in the air stream with the square to round transitions, which can be provided.
Hump magnetic separators consist of two plate magnets, which are hinged and gasket to the rugged steel housing. These plate magnets can be unlatched and swing open for quick manual cleaning.
Based on the configuration magnetic hump separators are of following types:
Pneumatic control self-cleaning hump magnets provide safe and easy operations. Self-cleaning hump magnets are easy to operate magnetic separator, which removes various contaminations. The cleaning of the separator can be accomplished within few minutes. It consists of magnets and pneumatic discharge gate, which allows the release of the tramp iron collected through a special discharge chute. The magnets and the gate resume the work of processing as soon as the cleaning operation is completed.
Half Hump Magnets The half hump magnets are used where hump magnets will not fit because of height restrictions. Like its larger version, the half-hump housing directs the material flow over the single high-strength permanent magnet and breaks up aggregated material to dislodge and capture embedded metal contaminants.
Our other conveyor belts are:
Hopper Magnet, Plate Magnets, Spout Magnet, Drawer Magnet, Horse Shoe Magnet, Hand Magnet, Magnetic Rods, Hump Magnet, Electro Magnetic Hammer, Electro Magnetic Vibratory Feeder, Electro Magnetic Pulsating Vibrator, Roller Type Magnetic Separator, Channel Magnet, Magnetic Floor Sweeper, Magnetic Drum Pulley, Magnetic Lifter, Suspension Magnet, Single Drum Type Magnetic Separator, Double Drum Type Magnetic Separator, Inline Drum Type Magnetic Separator, Wet Drum Separator, Permanent Magnetic Belt Type Separator, Magnetic Coolant Separator, Overband Magnetic Separator